Tile film, concrete, dark grey

Assembly instructions for Tile foils (self-adhesive)

You will need the following items

• Plastic bottle with hand sprayer, adhesive tape, paper towels (not included)
• Transfer concentrate (not included)
• Glass cleaner (not included) or commercially available glass cleaner
• Installation squeegee and glass scraper blade (included free of charge in the delivery).

Installation tips

• Two people should carry out the installation!
• Do not install any film at temperatures on the installation side below +6° C.

1. Fill the spray bottle with 0.5 litres of water and add the transfer concentrate (30 ml) (enough for approx. 6 to 7 m² of glass surface).
2. Thoroughly clean the glass with commercial or our glass cleaner!
   Remove all sticky particles (e.g. paint or fly dirt) preferably with the glass scraper blade. No dirt residues should remain on the glass!
3. The sandblasting foil consists of the mostly white backing paper and the actual sandblasting foil.
   Now place the sandblasting foil with the view side down on the glass pane or similar. You are now looking at the back of the film.
   Then carefully and slowly peel off the backing paper at as shallow an angle as possible until it is about halfway along the entire length of the film. Cut the backing paper and stick it back onto the sandblasting film with a gap of about 2 cm to the remaining backing paper.
4. Now hold the in place while the 2nd person starting from the corner, and at the same time spray the adhesive side of the that is now exposed with the liquid.
   Afterwards, the glass pane (surface to be pasted) must be sprayed with the liquid. Do not be sparing with the liquid, the film and pane should be well wet.
5. Place the on the glass, the film should slide back and forth well, otherwise spray the glass again.
6. Now spray the other side of the as well, this will make it easier for you to work with the mounting squeegee.
7. Now press the liquid out evenly with the mounting squeegee from the centre to the right and to the left. Make sure that there is no residual water left under the film! Repeat this procedure several times to remove even invisible water residues. When doing this, wrap the supplied squeegee with a paper towel to avoid any scratches.
8. Carefully wipe the edges and the foil with a soft cloth. If necessary, press the edges again with the mounting squeegee.
9. Now let the dry for three days without touching it.
10. Wait two weeks before cleaning the film for the first time and never use hard objects (brush or blade) to clean it. Commercially available glass cleaners can be used.

FAQ`s about the installation